No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the SD and SF Alarm Threshold

Configuring the SD and SF Alarm Threshold

Context

Different services allow different bit error rates. Configure the error rate alarm threshold for a POS interface so that an alarm is reported when the link performance deteriorates. Network administrators can locate and process link faults based on the alarms.

The Signal Degrade (SD) and Signal Fail (SF) alarms indicate the current link performance. Their generation reasons are both that the receiver detects error codes. The difference is that an SD alarm is reported when a small number of error codes are detected and an SF alarm is reported when a large number of error codes are detected.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface pos interface-number

    The POS interface view is displayed.

  3. Run threshold { sd | sf } value

    The SD and SF alarm threshold is configured for the POS interface.

    The default SD alarm threshold is 10e-6 and the default SF alarm threshold is 10e-3.

    The SD alarm threshold must be smaller than the SF alarm threshold.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 22686

Downloads: 127

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next