No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Parameters for a VDSL Interface

Setting Parameters for a VDSL Interface

Prerequisites

The VDSL interface has been deactivated.

Context

The router used as the CPE and the peer device must use the same transmission standard, bit exchange status, seamless rate adaptation status, and trellis coding status so that they can communicate.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface atm interface-number

    The VDSL interface view in ATM mode is displayed.

  3. Run adsl standard { adsl2 [ annexa | annexm | annexb | annexj | annexl ] | adsl2+ [ annexa | annexm | annexb | annexj ] | auto [over-pots | over-isdn ] | gdmt [ annexa | annexb ] | t1413 }

    The transmission standard is configured for the VDSL interface in ATM mode.

    By default, a VDSL interface in ATM mode transmission standard is auto.

    NOTE:

    AR109, AR109W, AR109GW-L, AR129, AR129CVW, AR129CV, AR129GW-L, AR129CGVW-L, AR129W, AR169, AR169CVW, AR169CVW-4B4S, AR169G-L, AR169-P-M9, AR169W-P-M9, and AR169RW-P-M9 do not support T1.413.AR169EW, AR169EGW-L, AR169F, AR169BF, AR169FVW, AR169FVW-8S, AR169FGW-L, AR169JFVW-4B4S, AR169JFVW-2S,and AR169FGVW-L only support AnnexA and AnnexM. AR169BF only supports AnnexB and AnnexJ.

  4. Run adsl bitswap { off | on }

    Bit exchange is configured on the VDSL interface.

    By default, bit exchange is enabled on a VDSL interface.

  5. Run adsl sra { off | on }

    Seamless rate adaptation is configured on the VDSL interface.

    By default, seamless rate adaptation is disabled on a VDSL interface.

  6. Run adsl trellis { off | on }

    Trellis coding is configured on the VDSL interface.

    By default, trellis coding is enabled on a VDSL interface.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21090

Downloads: 95

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next