No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Understanding E&M Interfaces

Understanding E&M Interfaces

This section describes the process of transparently transmitting E&M data through an MPLS tunnel.

As shown in Figure 10-1, the E&M data transceiver connects to the E&M terminal in wired or wireless mode and connects to the remote data processing center through the IP/MPLS network.

RouterA connects to the data processing center through an E&M interface, and RouterB connects to the E&M data transceiver through an E&M interface. RouterA and RouterB have set up an MPLS tunnel between them.

Figure 10-1  Transparent transmission of E&M data through the MPLS tunnel

When the data processing center needs to transmit data to the E&M terminal, the E&M data is transparently transmitted through the MPLS tunnel as follows:

  1. The E&M interface of RouterA receives E&M data from the data processing center.
  2. RouterA encapsulates E&M data into a PWE3 packet.
  3. RouterA transparently transmits the PWE3 packet to RouterB through the MPLS tunnel.
  4. RouterB parses E&M data from the PWE3 packet and transmits the E&M data through the E&M interface to the E&M data transceiver.
  5. The E&M data transceiver transmits the E&M data to the E&M terminal in wired or wireless mode.

The process of transmitting data from the E&M terminal to the data processing center is the reverse of the preceding process.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21166

Downloads: 95

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next