No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Multiplexing E1/T1 to STM-1

Multiplexing E1/T1 to STM-1

In the process of SDH multiplexing recommended in G.709, there is more than one multiplexing path from a valid payload to STM-N.

Figure 15-4 and Figure 15-5 show the multiplexing from E1/T1 to STM-1.

Figure 15-4  Process of multiplexing E1 to STM-1

Figure 15-5  Process of multiplexing T1 to STM-1

In application, different countries and regions may adopt different multiplexing paths. To ensure mutual communication, the device provides the multiplex mode command on the CPOS interface so that you can select the AU-3 or AU-4 multiplexing path.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21322

Downloads: 97

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next