No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for POS Interfaces

Default Settings for POS Interfaces

This topic describes the default values of the common POS parameters.

Table 14-1  Default settings for POS interfaces

Parameter

Default Value

Frame format

SDH

Link-layer protocol

PPP

Clock mode

Slave

MTU

1500 bytes

Overhead bytes

C2: 0x16

J0 and J1 are both blank character strings.

Payload scrambling

Enabled

CRC check character length

32 bits

Alarm threshold

10e-6 for Signal Degrade (SD)

10e-3 for Signal Fail (SF)

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21039

Downloads: 93

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next