No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Logs and Thresholds for Outbound and Inbound Bandwidth Usage

Configuring Logs and Thresholds for Outbound and Inbound Bandwidth Usage

Context

The bandwidth usage represents the load on a device. If the bandwidth usage exceeds the threshold, bandwidth of the device is insufficient for services and needs expansion. For example, if the bandwidth usage exceeds 95%, an alarm is generated to indicate that bandwidth resources are used up. Services may be interrupted before system expansion. You can set the upper and lower thresholds for bandwidth usage. When the bandwidth usage exceeds the lower threshold, the system generates a log. When the bandwidth usage exceeds the upper threshold, the system triggers an alarm.

The lower threshold must be smaller than the upper threshold. For example, you can set the lower threshold to 80% and the upper threshold to 95%. When the bandwidth usage exceeds 80%, the system generates a log, alerting users that the system needs expansion. When the bandwidth usage exceeds 95%, the system generates an alarm to prevent service interruption.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run log-threshold { input-rate | output-rate } bandwidth-in-use [ resume-rate resume-threshold ]

    The log thresholds for the outbound or inbound bandwidth usage on the interface are configured.

    By default, the log thresholds of the outbound and inbound bandwidth usage are both 100.

    NOTE:

    Maintain a proper gap between the bandwidth-in-use and resume-threshold values to prevent log flapping.

  4. Run trap-threshold { input-rate | output-rate } bandwidth-in-use [ resume-rate resume-threshold ]

    The alarm thresholds for the outbound or inbound bandwidth usage on the interface are configured.

    By default, the alarm thresholds of the outbound and inbound bandwidth usage are both 100.

    NOTE:

    Maintain a proper gap between the bandwidth-in-use and resume-threshold values to prevent alarm flapping.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21346

Downloads: 97

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next