No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Why Does the Status of the Connected Ethernet Interfaces Change Between Up and Down?

Why Does the Status of the Connected Ethernet Interfaces Change Between Up and Down?

This problem occurs because auto-negotiation is enabled on one interface but disabled on the other interface. Configure both interfaces to work in the same auto-negotiation mode. When auto-negotiation is enabled on one interface but disabled on the other interface, packet loss may occur even when both interfaces are in the Up state.

This problem may also occur when the network cable is loose.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21162

Downloads: 95

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next