No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration

Verifying the Configuration

Procedure

  • Run the display interface [ interface-type [ interface-number ] ] command to check information about an interface, including interface running status, basic interface configuration, and packet transmitted through the interface.
  • Run the display interface brief command to check brief information about interfaces, including the physical status, protocol status, bandwidth usage in the inbound and outbound directions during a certain period of time, and the number of error packets sent and received on each interface.
  • Run the display interface description [ interface-type [ interface-number ] ] [ main ] command to check the interface description.
  • Run the display interface ethernet brief command to check brief information about Ethernet interfaces, including the physical status, negotiation mode, duplex mode, rate, and average bandwidth usage in the inbound and outbound directions on each interface within the last period of time.
  • Run the display port-isolate group { group-id | all } command to check information about interface isolation groups.
  • Run the display error-down recovery [ interface interface-type interface-number ] command to check information about an error-down interface.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 22840

Downloads: 127

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next