No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for T1-F Interfaces

Default Settings for T1-F Interfaces

This section provides the default settings for a T1-F interface.

Table 9-1  Default settings for a T1-F interface

Parameter

Default Setting

Working mode of the 1E1T1-F/2E1T1-F interface card

e1-f (E1-F mode)

Working mode of the T1-F interface

Framed mode

Timeslot bundling

All timeslots bundled into one channel, with a rate of 1536 kbit/s (The default rate of a timeslot is 64 kbit/s.)

Attenuation or length of the transmission line matching the T1-F interface

long -7.5db

Clock mode

Line clock mode (slave)

Line idle code

0x7e

Interframe filling tag type and minimum number of interframe filling tags

Interframe filling tag type: 0x7e; minimum number of interframe filling tags: 4

CRC mode

16-bit CRC

Whether to invert data

No

Whether to perform RAI detection (in framed mode)

Yes

Alarm thresholds

  • Alarm Indication Signal (AIS) alarm threshold: level 1
  • Loss of Frame Alignment (LFA) alarm threshold: level 1
  • Loss of Signal (LOS) alarm threshold: The value of pulse-detection is 176 and the value of pulse-recovery is 22, indicating that a LOS alarm is generated if less than 22 pulses are detected within 176 pulse intervals.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20928

Downloads: 93

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next