No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the bandwidth of an interface

Setting the bandwidth of an interface


The bandwidth command mainly ensures that the network management station (NMS) can acquire the bandwidth of an interface. The NMS can check the interface bandwidth through the two objects ifSpeed and ifHighSpeed in IF-MIB.
  • If the configured bandwidth is smaller than 4000 Mbit/s, ifSpeed and ifHighSpeed are respectively displayed as bandwidth x 1000 x 1000 and bandwidth.
  • If the configured bandwidth is equal to or larger than 4000 Mbit/s, ifSpeed and ifHighSpeed are respectively displayed as 4294967295 (0XFFFFFFFF) and bandwidth.


  • Run system-view

    The system view is displayed.

  • Run interface interface-type interface-number

    The interface view is displayed.

  • Run bandwidth bandwidth [ kbps ]

    The bandwidth of an interface is set.

Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21153

Downloads: 95

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next