No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Working Mode of a Combo Interface

Configuring the Working Mode of a Combo Interface

Context

If a combo interface is forcibly configured to work in a different mode from the remote interface, the two interfaces cannot communicate.

A combo interface can not be changed from Layer 3 mode to Layer 2 mode.

Combo interfaces are logic interfaces. One combo interface can work as a GE electrical interface or a GE optical interface. Each combo interface has only one internal forwarding interface. When the electrical interface is enabled, the optical interface is disabled. When the optical interface is enabled, the electrical interface is disabled. Set the working mode of combo interfaces according to network requirements. The electrical and optical interfaces of a combo interface use the same interface view. You can enable the electrical or optical interface, and configure interface attributes such as the rate and duplex mode in the same interface view.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface gigabitethernet interface-number

    The Gigabit Ethernet interface view is displayed.

  3. Run combo-port { auto | copper | fiber }

    The working mode of the combo interface is configured.

    A combo interface works in auto mode and automatically works as an optical or electrical interface by default.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20781

Downloads: 91

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next