No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Traffic Statistics Collection Interval

Configuring the Traffic Statistics Collection Interval

Context

By setting the traffic statistics collection interval, you can collect and analyze packet statistics. According to traffic statistics, you can take measures to prevent network congestion and service interruption.

  • When congestion occurs, you can set the statistics collection interval on an interface to 300 seconds or less (30 seconds if congestion worsens). Then observe traffic distribution on the interface within a short period of time. Take measures to data packets that cause congestion to control the rate of the packets.

  • When the network bandwidth is sufficient and services are running properly, set the statistics collection interval on an interface to more than 300 seconds. If traffic parameters on an interface are out of the specified range, change the statistics collection interval to observe the traffic statistics in real time.

NOTE:
  • The interval set in the system view takes effect on all the interfaces that use the default interval.

  • The interval set in the interface view takes effect only on this interface.

  • The interval set in the interface view takes precedence over the interval set in the system view.

  • The new interval takes effect after the original interval expires. Traffic statistics on logical interfaces are displayed in the second periodical update after the new interval takes effect. Traffic statistics on physical interfaces are displayed when the new interval takes effect.

Procedure

  • Configure the global traffic statistics collection intervals in the system view.
    1. Run system-view

      The system view is displayed.

    2. Run set flow-stat interval interval-time

      The global traffic statistics collection interval is set.

      By default, the global traffic statistics collection interval is 300s.

  • Configure the traffic statistics collection interval on an interface.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. Run set flow-stat interval interval-time

      The traffic statistics collection interval is set on the interface.

      By default, the traffic statistics collection interval on an interface is 300s.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20938

Downloads: 93

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next