No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Aging Time of Group Member Ports

Setting the Aging Time of Group Member Ports

Context

A router sets the aging time of a member port depending on the Multicast Listener Discovery (MLD) message received:
  • When the member port receives a Report message from a downstream host, the device sets the aging time to: Robustness variable x General Query interval + Maximum response time for General Query messages.

  • When the member port receives a Done message from a downstream host, the device sets the aging time to: Last member query interval x Robustness variable.

When deploying a Layer 2 multicast network, ensure that all the Layer 2 multicast devices use the same parameter values to calculate the aging time of dynamic group member ports, especially the MLD snooping general query interval. Otherwise, errors may occur in Layer 2 multicast forwarding.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The VLAN view is displayed.

  3. Run mld-snooping query-interval query-interval

    The MLD snooping general query interval is configured.

    By default, the MLD snooping general query interval is 60 seconds.

  4. Run mld-snooping robust-count robust-count

    The MLD snooping robustness variable is configured.

    By default, the MLD snooping robustness variable is 2.

  5. Run mld-snooping max-response-time max-response-time

    The MLD snooping maximum response time is set.

    By default, the MLD snooping maximum response time is 10 seconds.

  6. Run mld-snooping last-listener-query-interval query-interval

    The MLD snooping last member query interval is configured.

    By default, the MLD snooping last member query interval is 1 second.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 21665

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next