No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic IPv6 PIM-DM Functions

Configuring Basic IPv6 PIM-DM Functions

Pre-configuration Tasks

Before configuring basic IPv6 PIM-DM functions, configure an IPv6 unicast routing protocol to ensure normal unicast routing on the IPv6 network.

Context

IPv6 PIM-DM and IPv6 PIM-SM cannot be enabled simultaneously on the device.

It is recommended that you enable IPv6 PIM-DM on all interfaces on an IPv6 PIM-DM network, so that the interfaces can establish neighbor relationships with all connected PIM devices.

If IPv6 PIM-DM and MLD need to be enabled on the same interface, enable IPv6 PIM-DM, and then enable Multicast Listener Discovery (MLD).

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run multicast ipv6 routing-enable

    The IPv6 multicast routing function is enabled.

  3. Run interface interface-type interface-number

    The interface view is displayed.

  4. Run pim ipv6 dm

    IPv6 PIM-DM is enabled on the interface.

Verifying the Configuration

After IPv6 PIM-DM is enabled on all the interfaces in an IPv6 PIM domain, use the following commands to check information about IPv6 PIM interfaces, IPv6 PIM neighbors, and IPv6 PIM routing entries.

  • Run the display pim ipv6 interface [ interface-type interface-number | up | down ] [ verbose ] command to check IPv6 PIM information on an interface.

  • Run the display pim ipv6 neighbor [ ipv6-link-local-address | interface interface-type interface-number | verbose ] * command to check information about IPv6 PIM neighbors.

  • Run the following commands to check the IPv6 PIM routing table:

    • Run the display pim ipv6 routing-table [ ipv6-source-address [ mask mask-length ] | ipv6-group-address [ mask mask-length ] | flags flag-value | fsm | incoming-interface { interface-type interface-number | register } | mode { dm | sm | ssm } | outgoing-interface { exclude | include | match } { interface-type interface-number | none | register } ] * [ outgoing-interface-number [ number ] ] command to check detailed information about the IPv6 PIM routing table.

    • Run the display pim ipv6 routing-table brief [ ipv6-source-address [ mask mask-length ] | ipv6-group-address [ mask mask-length ] | incoming-interface { interface-type interface-number | register } ] * command to check brief information about the IPv6 PIM routing table.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 22189

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next