No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Controlling SA Messages and the SA Cache

Controlling SA Messages and the SA Cache


MSDP peers share (S, G) information by exchanging Source-Active (SA) messages. To control SA message transmission, you can configure the SA cache size, enable the local device to send SA request messages, encapsulate multicast data in SA messages, and configure policies to filter SA messages and SA request messages.

Pre-configuration Tasks

Basic MSDP functions have been configured. For details, see Configuring Basic MSDP Functions.

Configuration Procedure

The following configuration tasks can be performed at any sequence as required.

Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 24400

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next