No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
SPT on a PIM-DM Network Fails to Be Established

SPT on a PIM-DM Network Fails to Be Established

Fault Description

After PIM-DM configuration is complete on a network, user hosts use Internet Group Management Protocol (IGMP) to send requests to group G. However, the user hosts cannot receive any multicast data.

Procedure

  1. Check whether a reachable unicast route to the multicast source is available.

    Run the display ip routing-table command to check whether the router has a unicast route to the multicast source.

    Multicast routing depends on unicast routing. If the router does not have a unicast route to the multicast source, configure a unicast routing protocol to dynamically generate a route or configure a unicast static route to the multicast source.

  2. Check whether PIM-DM is enabled on interfaces, especially the reverse path forwarding (RPF) interface towards the multicast source.

    Run the display pim interface command to check PIM information on each interface.

    If no PIM information is displayed on an interface or the PIM mode on the interface is sparse, PIM-DM is not enabled on the interface. Run the pim dm command in the interface view to enable PIM-DM.

  3. Check whether IGMP is enabled on the interface directly connected to the network segment of the user hosts.

    Run the display igmp interface command to check the IGMP configuration on the interface directly connected to the network segment of the user hosts.

    If no information is displayed, IGMP is not enabled on the interface. Run the igmp enable command in the interface view to enable IGMP.

  4. Check whether a source-based filtering policy is used on the router.

    Run the display current-configuration configuration pim command to check the current configuration in the PIM view.

    If the command output contains "source-policy acl-number" or "source-policy acl-name", a source-based filtering policy is configured. If the received multicast data is not in the range permitted by the ACL, the router drops the multicast data. Run the undo source-policy command to delete the source-based filtering policy or configure new ACL rules to permit the multicast data requested by the user hosts.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 24360

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next