No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the IGMP Snooping Running Status

Monitoring the IGMP Snooping Running Status

Context

To check the IGMP snooping running status during routine maintenance, run the following display commands in any view.

Procedure

  • Run the display igmp-snooping [ vlan [ vlan-id ] ] command to check all the IGMP snooping running parameters in a VLAN.
  • Run the display igmp-snooping [ vlan [ vlan-id ] ] configuration command to check the IGMP snooping configuration in a VLAN.
  • Run the display igmp-snooping port-info [ vlan vlan-id [ group-address group-address ] ] [ verbose ] command to check information about member ports.
  • Run the display igmp-snooping router-port vlan vlan-id command to check information about router ports.
  • Run the display igmp-snooping querier vlan [ vlan-id ] command to check information about the IGMP snooping querier.
  • Run the display igmp-snooping statistics vlan [ vlan-id ] command to check IGMP snooping statistics.
  • Run the display l2-multicast forwarding-table vlan vlan-id [ [ source-address source-address ] group-address { group-address | router-group } ] command to check the layer-2 multicast forwarding table in a VLAN.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 24414

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next