No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of Parameters for Controlling the MFIB

Verifying the Configuration of Parameters for Controlling the MFIB

Context

After configuring the parameters for controlling the IPv6 MFIB, check the IPv6 MFIB to verify that the multicast network is operating properly.

Procedure

  • Run the display multicast ipv6 forwarding-table [ ipv6-source-address [ ipv6-source-mask-length ] | ipv6-group-address [ ipv6-group-mask-length ] | incoming-interface { interface-type interface-number | register } | outgoing-interface { { exclude | include | match } { interface-type interface-number | register | none } } | { statistics | verbose } ] * command to check the IPv6 MFIB.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 22079

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next