No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Parameters for Controlling the IPv6 Multicast Forwarding Table

Configuring the Parameters for Controlling the IPv6 Multicast Forwarding Table

Pre-configuration Tasks

Before configuring IPv6 multicast load splitting, complete the following tasks:

  • Configure an IPv6 unicast routing protocol to ensure normal unicast routing on the IPv6 network.
  • Globally enable Layer 3 IPv6 multicast routing (using the multicast ipv6 routing-enable command in the system view).

Configuration Procedure

The following configuration tasks can be performed at any sequence as required.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 23828

Downloads: 65

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next