No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Sending Query Messages Upon Network Topology Change

Sending Query Messages Upon Network Topology Change

Context

When Layer 2 network topology changes, the forwarding path of multicast packets may change. After the router is configured to send Multicast Listener Discovery (MLD Query messages when the link fails, the device updates information about multicast member ports according to the MLD Report messages replied by multicast members. In this way, multicast traffic can be quickly switched to new forwarding paths.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mld-snooping send-query enable

    The device is configured to send MLD General Query messages when network topology changes.

    By default, the device does not send MLD General Query messages when network typology changes.

    After this command is executed, the device can detect the Layer 2 network topology change and send MLD General Query messages. This ensures that the device can promptly update the interface information and the multicast data received by multicast group members is not interrupted.

  3. (Optional) Run mld-snooping send-query source-address ipv6-address

    The source IPv6 address of the MLD General Query message is configured.

    By default, the source IPv6 address of the MLD General Query message is a link local address, that is, an IPv6 address starting with FE80::. If this address has been used by other devices on the network, run this command to change the source IP address of an MLD General Query message.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 21512

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next