No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Static Router Port

(Optional) Configuring a Static Router Port


A router port is located on a Layer 2 device and connects to an upstream Layer 3 device (a multicast router or Layer 3 switch). When IGMP snooping is enabled in a VLAN, all interfaces in this VLAN learn forwarding entries from multicast protocol packets. When an interface receives IGMP Query messages or Protocol Independent Multicast (PIM) Hello messages, the Layer 2 device sets this interface as a dynamic router port. A router port provides the following functions:

  • Receives multicast data from the upstream device.
  • Forwards IGMP Report/Leave messages. IGMP Report/Leave messages received in a VLAN are forwarded only to router ports in the VLAN.

A dynamic router port has an aging time. If a dynamic router port does not receive an IGMP Query or a PIM Hello message before the aging time expires, the device deletes the port from the router port list. To enable an interface to forward IGMP Report/Leave messages to the upstream querier for a long time, configure the interface as a static router port.


  1. Run system-view

    The system view is displayed.

  2. (Optional) Run vlan vlan-id

    The VLAN view is displayed.

  3. (Optional) Run undo igmp-snooping router-learning

    Dynamic router port learning is disabled.

    By default, dynamic router port learning is enabled in a VLAN.

  4. (Optional) Run quit

    Exit from the VLAN view.

  5. Run interface interface-type interface-number

    The interface view is displayed.

  6. Run igmp-snooping static-router-port vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>

    An interface is configured as a static router port.

Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 21604

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next