No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for IPv4 Multicast Route Management

Default Settings for IPv4 Multicast Route Management

Table 7-8 lists the default settings for IPv4 multicast route management.

Table 7-8  Default settings for IPv4 multicast route management
Parameter Default Setting

Longest match rule for multicast route selection

Not configured. The reverse path forwarding (RPF) route is selected based on router preference during an RPF check.

Multicast load splitting

Disabled. Only one route is selected to forward multicast packets.

Multicast boundary

Not configured.

Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 24124

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next