No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of MLD Performance Parameters

Verifying the Configuration of MLD Performance Parameters

Context

After completing the preceding configuration, you can run the following commands in any view to check the adjusted membership information, MLD configuration, and MLD running status.

Procedure

  • Run the display mld interface [ interface-type interface-number | up | down ] [ verbose ] command to check the MLD information on an interface.
  • Run the display mld group [ ipv6-group-address | interface interface-type interface-number ]* [ verbose ] command to check information about MLD groups that hosts have dynamically joined by sending Multicast Listener Report messages.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 18122

Downloads: 44

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next