No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Range of Multicast Groups That an Interface Can Join

(Optional) Configuring the Range of Multicast Groups That an Interface Can Join


To control the range of multicast groups that hosts on an interface's network segment can join, use an access control list (ACL) to filter Membership Report messages received on the interface. This ACL allows the router to maintain only memberships of the interface in these multicast groups. For details on how to configure an ACL, see "ACL Configuration" in the Huawei AR100&AR120&AR150&AR160&AR200&AR1200&AR2200&AR3200&AR3600 Series Enterprise Routers Configuration Guide - Security.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run igmp group-policy { acl-number | acl-name acl-name } [ 1 | 2 | 3 ]

    An ACL is applied to specify the range of multicast groups that the interface can join.

    By default, an interface can join any multicast group.


    When configuring an ACL rule for an interface, use the permit parameter in the rule command to allow hosts connected to the interface to join groups within the specified range. If no rule is configured in the ACL, hosts connected to the interface cannot join any groups.

Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 23841

Downloads: 65

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next