No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MSDP

Enabling MSDP


To enable all rendezvous points (RPs) on a network to share source information and to minimize the number of MSDP—enabled devices, it is recommended that you configure MSDP only on the RPs on the network.

After MSDP is enabled, the MSDP view is displayed. You can perform other MSDP configurations in the MSDP view. Enabling MSDP is the prerequisite for other MSDP configurations.


  1. Run system-view

    The system view is displayed.

  2. Run msdp [ vpn-instance vpn-instance-name ]

    MSDP is enabled and the MSDP view is displayed.

Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 22265

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next