No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IGMP Proxy

Configuring IGMP Proxy

Context

In a simple tree topology, multicast devices directly connected to receiver hosts do not need to run complicated multicast routing protocols, such as PIM. To conserve network bandwidth and reduce loads on the upstream devices, you can configure IGMP proxy on the multicast devices. Then the multicast devices work as proxy devices between the upstream devices and downstream hosts and substitute for them to transmit IGMP messages.

Pre-configuration Tasks

Before configuring IGMP proxy, complete the following tasks:

  • Configuring a unicast routing protocol to ensure reachable IP routes between network nodes
  • Globally enabling IP multicast routing

Configuration Procedure

Perform the IGMP proxy configuration in listed order.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 24700

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next