No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IGMP Snooping SSM Mapping Functions

Configuring IGMP Snooping SSM Mapping Functions

Context

  • By configuring Source-Specific Multicast (SSM) mapping, you can set up one-to-one mappings between multicast groups and multicast sources.

  • SSM mapping applies only to the scenario where IGMP snooping in the VLAN can process IGMPv3 messages.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The VLAN view is displayed.

  3. Run igmp-snooping version 3

    The version of IGMP snooping run in the VLAN is set to 3.

    The default version number of IGMP snooping is 2, but IGMPv2 version does not support SSM mapping.

  4. Run igmp-snooping ssm-mapping enable

    SSM mapping is enabled in the VLAN.

    By default, SSM mapping is disabled in a VLAN.

  5. Run igmp-snooping ssm-mapping group-address { group-mask | mask-length } source-address

    The mapping between a group address and a multicast source address is configured.

    The group address must be in the SSM group address range. If you want to change the SSM group address range, see (Optional) Configuring an SSM Group Policy.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069332

Views: 24257

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next