No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Service

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an ISATAP Tunnel

Configuring an ISATAP Tunnel


When configuring an ISATAP tunnel, note the following points:

  • You must create a tunnel interface before setting tunnel parameters.

  • You are advised to set the tunnel number to be the same as the number of the source physical interface of the tunnel.

  • You can specify an IP address or interface name for the source interface (the source interface of a tunnel is the physical interface that forwards tunnel packets).

  • You need to configure an ISATAP address with a 64-bit prefix-length as the IPv6 address of a tunnel interface.


  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel interface-number

    A tunnel interface is created.

  3. Run tunnel-protocol ipv6-ipv4 isatap

    The tunnel mode is set to ISATAP.

  4. Run source { source-ip-address | interface-type interface-number }

    A source address or source interface is specified for the tunnel.

  5. Run ipv6 enable

    The IPv6 function is enabled on the interface.

  6. Run ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }

    An IPv6 address is configured for the tunnel interface.

  7. Run undo ipv6 nd ra halt

    The device is enabled to send router advertisement (RA) packets.

Updated: 2019-03-06

Document ID: EDOC1100069333

Views: 36828

Downloads: 188

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next