No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Service

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for ARP

Default Settings for ARP

This section describes default settings for ARP.

Table 2-4 lists the default settings for ARP.

Table 2-4  Default settings for ARP

Parameter

Default Setting

Aging time of dynamic ARP entries

1200s

Maximum number of ARP aging probes

3

Mode in which an interface sends ARP aging probe packets

An interface only broadcasts the last ARP aging probe packet, and unicasts other ARP aging probe packets.

Routed proxy ARP

Disabled

Intra-VLAN proxy ARP

Disabled

Inter-VLAN proxy ARP

Disabled

Dynamic Learning of ARP Entries with Multicast MAC Addresses

Disabled

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069333

Views: 32860

Downloads: 166

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next