No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Service

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Public Address Cannot Be Pinged When NAT Is Configured on the Device as the Egress Gateway. How Do I Solve the Problem?

Public Address Cannot Be Pinged When NAT Is Configured on the Device as the Egress Gateway. How Do I Solve the Problem?

After outbound NAT is configured, run the ip soft-forward enhance enable command to enable the enhanced IP forwarding function before running the ping -a source-ip-address host command. The device then does not translate private source addresses into public addresses when sending packets.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069333

Views: 32547

Downloads: 158

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next