No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Service

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the IPv4 over IPv6 Tunnel Configuration

Verifying the IPv4 over IPv6 Tunnel Configuration

Prerequisites

All configurations of the IPv4 over IPv6 tunnel are complete.

Procedure

  • Run the display interface tunnel [ interface-number ] command to check the running status of the tunnel interface.
  • Run the display ip routing-table command to check the routing table.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069333

Views: 33753

Downloads: 171

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next