No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Service

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Internal NAT Server Configuration

Verifying the Internal NAT Server Configuration


  • Run the display nat server [ global global-address | inside host-address [ vpn-instance vpn-instance-name ] | interface interface-type interface-number [ .subnumber ] | acl acl-number ] command to verify the configuration of the NAT server.
  • Run the display nat alg command to verify the NAT ALG configuration.
  • Run the display nat dns-map [ domain-name ] command to verify the configuration of DNS mapping.
  • Run the display nat overlap-address { map-index | all | inside-vpn-instance inside-vpn-instance-name } command to verify the configuration of twice NAT.
  • Run the display firewall-nat session aging-time command to check the aging time of NAT mapping entries.
  • Run the display nat sip cac bandwidth information [ verbose ] command to check the current total bandwidth and occupied bandwidth on the device.
  • Run the display nat filter-mode command to check the current NAT filtering mode.
  • Run the display nat mapping-mode command to check the NAT mapping mode.
  • Run the display nat mapping table { all | number } or display nat mapping table inside-address ip-address protocol protocol-name port port-number [ vpn-instance vpn-instance-name ] command to check the NAT table information or the number of entries in the NAT table.
Updated: 2019-03-06

Document ID: EDOC1100069333

Views: 35527

Downloads: 178

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next