No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Service

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Manual IPv6 over IPv4 Tunnel

Configuring a Manual IPv6 over IPv4 Tunnel


When configuring a manual IPv6 over IPv4 tunnel, note the following points:

  • You must create a tunnel interface before setting tunnel parameters.

  • When the specified tunnel source interface is a physical interface, you are advised to set the tunnel number and the tunnel source interface number to be the same.

  • The following configurations must be performed on devices at both ends of the tunnel.

  • To support a dynamic routing protocol, you can configure a network address for the tunnel interface.


  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel interface-number

    A tunnel interface is created.

  3. Run tunnel-protocol ipv6-ipv4

    The tunnel mode is set to manual.

  4. Run source { ip-address | interface-type interface-number }

    A source address or source interface is specified for the tunnel.

    You can specify a physical interface or a loopback interface as the source interface of a tunnel. Similarly, you can specify the IP address of a physical interface or loopback interface as the source address of the tunnel.

  5. Run destination dest-ip-address

    A destination address is specified for the tunnel.


    The destination address of a tunnel can be the IP address of a physical interface or loopback interface.

  6. Run ipv6 enable

    The IPv6 function is enabled on the interface.

  7. Run ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }

    An IPv6 address is configured for the tunnel interface.

Updated: 2019-03-06

Document ID: EDOC1100069333

Views: 37158

Downloads: 188

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next