No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Service

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the ARP Running Status

Monitoring the ARP Running Status


To check the ARP running status during routine maintenance, run the following commands in any view.


  • Run the display arp error packet command to check the last received 10 ARP error packets.
  • Run the display arp ip-conflict track command to check records about IP address conflicts detected.
  • Run the display arp packet statistics command to check ARP packet statistics.
  • Run the display arp track command to check changes of outbound interfaces in ARP entries learned by a VLANIF interface.
  • Run the display cpu-defend statistics packet-type arp-request command to check statistics on ARP Request packets sent to the CPU.
  • Run the display cpu-defend statistics packet-type arp-reply command to check statistics on ARP Reply packets sent to the CPU.
Updated: 2019-03-06

Document ID: EDOC1100069333

Views: 43204

Downloads: 200

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next