No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Service

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document describes the concepts and configuration procedures of IP Service features on the device, and provides the configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static Neighbors

Configuring Static Neighbors

Context

To communicate with a destination host, a host needs to obtain the destination host's link-layer address. The link-layer address of a neighbor node can be obtained using the neighbor discovery mechanism, or by manually configuring static neighbor entries. A device identifies a static neighbor entry based on the IPv6 address of this neighbor and number of the Layer 3 interface connected to this neighbor. To filter invalid packets, you can create static neighbor entries, binding the destination IPv6 addresses of these packets to nonexistent MAC addresses.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The specified interface view is displayed.

  3. Run one of the following commands based on the interface type:

    • Run ipv6 neighbor ipv6-address mac-address

      Static neighbor entries are configured on common Layer 3 interfaces.

    • Run ipv6 neighbor ipv6-address mac-address vid vlan-id interface-type interface-number

      Static neighbor entries are configured on VLANIF interfaces.

    • Run ipv6 neighbor ipv6-address mac-address vid vlan-id [ cevid cevid ]

      Static neighbor entries are configured on a QinQ or Dot1q termination subinterface.

      NOTE:
      If dynamic QinQ is enabled, static neighbor entries cannot be configured.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069333

Views: 33674

Downloads: 169

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next