Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Examples for MPLS TE
- Example for Configuring a Static MPLS TE Tunnel
- Example for Configuring a Dynamic MPLS TE Tunnel
- Example for Configuring a DS-TE Tunnel in Non-IETF Mode (MAM)
- Example for Configuring a DS-TE Tunnel in IETF Mode (RDM)
- Example for Configuring IGP Shortcut to Direct Traffic to an
MPLS TE Tunnel
- Example for Configuring Forwarding Adjacency to Direct Traffic
to an MPLS TE Tunnel
- Example for Setting Attributes for an MPLS TE Tunnel
- Example for Configuring Srefresh Based on Manual TE FRR
- Example for Configuring RSVP Authentication
- Example for Configuring RSVP Authentication Based on Manual
TE FRR
- Example for Configuring SRLG Based on Auto TE FRR
- Example for Configuring SRLG Based on CR-LSP Hot Standby
- Example for Configuring CR-LSP Hot Standby
- Example for Configuring Dynamic Bandwidth for a Hot-standby
CR-LSP
- Example for Configuring Manual TE FRR
- Example for Configuring Auto TE FRR
- Example for Configuring Association Between TE FRR and CR-LSP
Backup
- Example for Configuring Static BFD for CR-LSPs
- Example for Configuring Dynamic BFD for CR-LSPs
- Example for Configuring RSVP GR