No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
UDP Jitter (Hardware-based) Test

UDP Jitter (Hardware-based) Test

A UDP jitter (hardware-based) test is performed using UDP packets and is a supplement to the UDP jitter. This test has the following advantages:
  • Reduces the interval for sending packets. The minimum interval for sending packets can be 10 ms.

  • Increases the number of concurrent test instances.

  • Improves the accuracy of delay and jitter calculation.

These advantages enable the UDP jitter (hardware-based) test to accurately reflect the network status and improve device efficiency.
Table 7-1  Differences between UDP jitter and UDP jitter (hardware-based)

Comparison

UDP Jitter

UDP Jitter (Hardware-based)

Interval for sending packets

The minimum value is 20 ms.

The minimum value is 10 ms.

Jitter calculation

Timestamps are added to packets on the MPU.

Timestamps are added to packets on the LPU, which is more precise.

Figure 7-14  UDP jitter (hardware-based) test scenario

The UDP jitter (hardware-based) test results and historical records are collected in test instances. You can run commands to view the test results and historical records.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069336

Views: 30807

Downloads: 177

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next