CLI-based Configuration Guide - Network Management and Monitoring
AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003
This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Starting an NQA Test Instance
Starting an NQA Test Instance
Context
After completing the configuration of an NQA test instance, start the NQA test instance in following modes:
Start the NQA test instance immediately.
Start the NQA test instance at a specified time.
Start the NQA test instance after a delay.
If the test fails, restart the NQA test instance in the next time period.
NOTE:
If the number of running test instances reaches the maximum value defined by the system, the start command is invalid.
For the same test instance, the start now command can be used again only when the previous test is complete.
The specified time to start a test instance must be later than the current time of the device.