No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration

Verifying the Configuration

Prerequisites

The configurations of basic SNMPv3 functions are complete.

Procedure

  • Run the display snmp-agent usm-user [ user-name ] command to check user information.
  • Run the display snmp-agent group [ group-name ] command to check information about the SNMP user group.
  • Run the display snmp-agent sys-info version command to check the enabled SNMP version.
  • Run the display acl acl-number command to check ACL rules.
  • Run the display snmp-agent mib-view command to check MIB views.
  • Run the display snmp-agent sys-info contact command to check the administrator's contact information.
  • Run the display snmp-agent sys-info location command to check the location of the router.
  • Run the display current-configuration | include trap command to check trap configuration.
  • Run the display snmp-agent trap all command to check current and default status of all traps of all features.
  • Run the display snmp-agent trap-source command to check the source interface for sending traps.
  • Run the display snmp-agent target-host command to check information about the target host.
  • Run the display snmp-agent extend error-code status command to check whether the function that the device sends extended error codes to the NMS is enabled.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069336

Views: 30859

Downloads: 177

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next