No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Disabling LLDP on an Interface

(Optional) Disabling LLDP on an Interface


LLDP can be enabled in the system view and the interface view.

  • When LLDP is enabled in the system view, LLDP is enabled on all interfaces.
  • When LLDP is disabled in the system view, LLDP is disabled on all interfaces.
  • An interface can send and receive LLDP packets only after LLDP is enabled in both the system view and the interface view.
  • After LLDP is disabled globally, the commands for enabling and disabling LLDP on an interface do not take effect.
  • If LLDP needs to be disabled on some interfaces, first enable LLDP globally, and run the undo lldp enable command on these interfaces. To re-enable LLDP on these interfaces, run the lldp enable command in the views of these interfaces.
  • Only physical interfaces support LLDP. Logical interfaces such as the VLANIF and Eth-Trunk interfaces do not support LLDP.
  • On an Eth-Trunk, LLDP can only be enabled on member interfaces. LLDP status of a member interface does not affect that of another.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run undo lldp enable

    LLDP is disabled on the interface.

Updated: 2019-03-06

Document ID: EDOC1100069336

Views: 33186

Downloads: 189

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next