No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Can an AR Router Correctly Connect to an ACS?

How Can an AR Router Correctly Connect to an ACS?

  1. Ensure that the AR router can ping the ACS successfully.
  2. Ensure that the AR router is configured with the same URL as the ACS.
  3. Run the undo cwmp enable command and then the cwmp enable command in the CWMP view of the AR router to trigger a session connection.
  4. If no connection is established, the AR router and ACS may fail to exchange packets. Capture packets on the ACS to locate the packet exchange failure. After the packet exchange failure is rectified, perform step 3 again to trigger a session connection.
Updated: 2019-03-06

Document ID: EDOC1100069336

Views: 30845

Downloads: 177

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next