No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
A UDP Jitter Test Instance Fails to Be Started

A UDP Jitter Test Instance Fails to Be Started

Context

A UDP jitter test may fail to be started. This fault is commonly caused by incorrect settings of mandatory parameters of the test instance.

NOTE:

Generally, the following commands are used in the NQA view. Only the display commands can be used in any view.

Procedure

  1. Run the display nqa-agent admin-name test-name [ verbose ] command on the NQA client or run the display this command in the NQA view to check whether the test type is Jitter.

    • If so, go to Step 2.
    • If not, run the test-type jitter command to set the test type to UDP Jitter.

  2. Run the display nqa-agent admin-name test-name [ verbose ] command on the NQA client or run the display this command in the NQA view to check whether the destination IP address is configured.

    • If so, go to Step 3.
    • If not, run the destination-address ipv4 ip-address command in the NQA test instance view to configure the destination IP address.

  3. Run the display nqa-agent admin-name test-name [ verbose ] command on the NQA client or run the display this command in the NQA view to check whether the destination port is configured.

    If not, run the destination-port port-number command in the NQA view to configure the destination port.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069336

Views: 34501

Downloads: 196

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next