No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring NetStream RPF Check Failure Flow Statistics Exporting

Configuring NetStream RPF Check Failure Flow Statistics Exporting

Context

Statistics about flows that fail the RPF check can be exported only when you have specified at least one destination IP address and one destination UDP port number for the exported packets.

Procedure

  1. Run system-view

    The system view is displayed.

  2. (Optional) Run ip netstream as extend enable

    The supported BGP AS number range is set.

    By default, the BGP AS numbers range from 1 to 65535.

    Only the output packets of V9 or V10 support the 32-bit BGP AS numbers. The ip netstream as extend enable command needs to be executed to set the supported BGP AS number range to 1-4294967295.

  3. Run ip netstream export source ip-address

    The source address of the exported packets carrying flow statistics is configured.

  4. Run ip netstream export host ip-address port-number

    The destination IP address and destination UDP port number are configured for the flow statistics packets exported to the NSC.

    You can configure two destination IP addresses to implement NSC backup. To configure a third destination IP address, run the undo ip netstream export host command to delete an existing one first; otherwise, the system displays a message indicating that the maximum number of IP addresses is exceeded and the configuration fails.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069336

Views: 34175

Downloads: 196

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next