No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
The SNMP Host Cannot Connect to the NMS

The SNMP Host Cannot Connect to the NMS

Fault Description

The SNMP host cannot connect to the NMS.

Procedure

Check whether the SNMP configuration on the host is correct according to the following table.

Table 1-6  SNMP configuration

Item

Method

Procedure

Check whether the host supports the SNMP version used by the NMS for sending a login request.

Run the display snmp-agent sys-info version command to view the SNMP version of the host.

If the host does not support the SNMP version, run the snmp-agent sys-info version command to set the SNMP version on the host.

View the community string configured on the host.

Run the display snmp-agent community command.

If the community string used by the NMS for sending a login request is different from that configured on the host, run the snmp-agent community command to configure a read-write community string, which must be the same as that configured on the host.

If SNMPv3 is used, check whether information about the SNMP user group and users is correct.

  • Run the display snmp-agent group command to view information about the SNMPv3 user group.
If information is incorrect, modify the configurations.
  • Run the snmp-agent group command to view information about the SNMPv3 user group.
  • Run the snmp-agent usm-user command to view information about the SNMPv3 user.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069336

Views: 30501

Downloads: 177

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next