No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Device to Communicate with an NMS by Running SNMPv3

Configuring a Device to Communicate with an NMS by Running SNMPv3

Pre-configuration Tasks

To allow a device to communicate with an NMS running SNMPv3, configure SNMPv3 on the device. The SNMP parameters must be configured on both the managed device (agent) and NMS. This section describes only the SNMP configurations on the agent side. For details about SNMP configurations on an NMS, see the NMS operation guide.

Before configuring a device to communicate with an NMS by running SNMPv3, configure a routing protocol to ensure that at least one route exists between router and NMS.

Configuration Process

When you configure the device to communicate with the NMS using SNMPv3, Configuring Basic SNMPv3 Functions is mandatory and optional steps can be performed in any sequence.

After the SNMP basic functions are configured, the NMS can communicate with managed devices.
  • The NMS using the specified community name can access the Viewdefault view. The internet MIB (OID: 1.3.6.1) and the lagMIB (OID: 1.2.840.10006.300.43) can be operated in this view.

  • The managed device sends traps generated by the modules that are enabled by default to the NMS.

The following are more configurations related to SNMPv3:
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069336

Views: 29514

Downloads: 172

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next