No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Failure to Manage CPE Using CWMP

Failure to Manage CPE Using CWMP

Symptoms

The fault symptoms are as follows:
  • The router cannot set up a connection with the ACS.
  • The ACS fails to issue configurations to the router.

Procedure

  1. Check that there is a reachable route between the router and ACS.

    Run the ping command on the router to ping the ACS.

    • If the ping fails, check the route configuration.
    • If the router can ping the ACS, go to step 2.

  2. Verify the CWMP settings on the router.

    Run the display cwmp configuration command to check whether the CWMP function is enabled and the ACS's URL, user name, and password are correctly set.

    <Huawei> display cwmp configuration
      CWMP is enabled
      ACS URL:                         http://www.acs.com:80/acs
      ACS username:                    hwcpe
      ACS password:                    %$%$gw1.QU~4M1I@RDF>b/VP,@7.%$%$
      Inform enable status:                 disabled
      Inform interval:                      600s
      Inform time:                          -
      Wait timeout:                         30s
      Reconnection times:                   3
    

    If the CWMP settings are incorrect, modify them based on Table 5-4, and run the undo cwmp enable and cwmp enable commands to re-enable the CWMP function.

    Table 5-4  CWMP settings
    Item Method
    Enable the CWMP function. Run the cwmp enable command in the CWMP view.
    Configure the URL used by the router to connect to the ACS. Run the cwmp acs url url command in the CWMP view.
    Configure the user name used by the router to connect to the ACS. Run the cwmp acs username username command in the CWMP view.
    Configure the ACS's password used by the router to connect to the ACS.

    Run the cwmp acs password cipher command in the CWMP view.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069336

Views: 29518

Downloads: 172

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next