No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Network Management and Monitoring

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples in different application scenarios of the network management feature supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LSP Trace Test

LSP Trace Test

The NQA LSP trace test detects the forwarding paths of LDP LSPs or TE LSPs and collects statistics about each device along a forwarding path.

Figure 7-8 shows the process of an LSP trace test:

  1. The source (PE-A) constructs a MPLS Echo Request packet whose destination IP field is an IP address on the block. The source then searches for the corresponding LSP. For a TE LSP, the packet can be sent from a tunnel interface and then forwarded along a specified CR-LSP.

    The MPLS Echo Request packet should contain the downstream mapping type-length-value (TLV) that carries LSP downstream information on the current node, including next-hop IP address and outbound label. The TTL of the first MPLS Echo Request packet is 1.

  2. The MPLS Echo Request packet is forwarded through the specified LSP in the MPLS domain. When the first hop of the LSP receives the packet, its TTL decreases to 0 and it times out. The first hop then returns an MPLS Echo Reply packet.

  3. The source continues to send MPLS Echo Request packets, with the TTL increasing by 1 each time. This process is repeated until all the LSRs along the LSP have returned their responses.

Figure 7-8  Network for LSP trace test

According to the reply packet received from each hop, the source obtains the LSP forwarding path from the source to the destination and collects statistics about each device along the forwarding path. The test result shows the LSP forwarding path from the source to the destination.

The LSP trace test results and historical records are collected in test instances. You can run commands to view the test results and historical records.

Updated: 2019-03-06

Document ID: EDOC1100069336

Views: 33056

Downloads: 189

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next