No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Reliability

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides guidance for configuring reliability services, including interface backup, BFD, VRRP, and EFM.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Association Between VRRP and BFD/NQA/Routing to Monitor the Uplink

Association Between VRRP and BFD/NQA/Routing to Monitor the Uplink

VRRP can detect only faults in VRRP groups. Association between a VRRP group and the interface status allows the device to detect faults on the uplink interface or direct uplink of the master. When an indirect uplink of the master fails, VRRP cannot detect the fault, causing user traffic loss. You can configure association between VRRP and BFD/NQA/routing to solve this problem. Association between VRRP and BFD/NQA/routing allows the device to detect faults on the uplink of the master. When the uplink of the master fails, BFD/NQA/routing rapidly detects the fault and notifies the master of adjusting its priority. This triggers an active/standby switchover and ensures proper traffic forwarding.

Figure 7-7  Association between VRRP and BFD/NQA/routing

As shown in Figure 7-7, a VRRP group is configured between RouterA and RouterB. RouterA is the master and RouterB is the backup. RouterA and RouterB work in preemption mode. BFD/NQA/routing is configured to detect faults on the link from RouterA to RouterE, and association between VRRP and BFD/NQA/routing is configured on RouterA. When BFD/NQA/routing detects the fault on the link from RouterA to RouterE, BFD/NQA/routing instructs the master to adjust its priority. RouterB becomes the master through negotiation, ensuring that user traffic is forwarded correctly.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069338

Views: 15420

Downloads: 56

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next