No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Reliability

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides guidance for configuring reliability services, including interface backup, BFD, VRRP, and EFM.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Association Between Interface Backup and NQA group

Configuring Association Between Interface Backup and NQA group

Applicable Environment

When the primary link is faulty, the interface backup module cannot detect the fault, causing service interruption. NQA technology measures network performance and collects statistics on the delay, jitter, and packet loss ratio in real time. To detect faults rapidly, configure association between interface backup and an NQA group to detect connectivity of multiple tunnels and to implement rapid switching when the primary link is faulty, ensuring service runs normally.

Pre-Configuration Tasks

Before configuring association between interface backup and NQA group, complete the following tasks:

An NQA group has been configured using the nqa-group command.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run nqa-group group-name

    An NQA group is created and the NQA group view is displayed.

  3. Run quit

    Return to the system view.

  4. Run interface interface-type interface-number

    The backup interface view is displayed.

  5. Run standby track nqa-group group-name

    Configure association between interface backup and NQA group.

    By default, interface backup is not associated with an NQA group.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069338

Views: 13898

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next