No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Guide for Interworking Between HUAWEI CloudFabric Solution and Redhat OpenStack

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the SUSE Operating System

Installing the SUSE Operating System

  1. In the network overlay scenario, directly install the SUSE operating system.

  2. Select the data storage ISO file, select Connected and Connect at power on, and click OK.
  3. Install the operating system for the Agile Controller-DCN.

  4. Press the down arrow key to select Installation and press Enter. The operating system installation page is displayed.

  5. For Perform Installation Configuration, the progress stays at 60% for about 10 minutes. Please wait.

  6. After the installation, the system restarts. During the restart, use the default value Boot from Hard Disk.

  7. The system performs initial configuration. Please wait.

  8. After the initial configuration is complete, the system restarts again. Ensure that the system boots from the hard disk again.
  9. After the operating system is started, the login page is displayed, indicating that the operating system is installed.
  10. Log in as the root user and swift user respectively. The default passwords of the two users are both Huawei12#$. Upon login as either user, change the password to MIMAshi@123 as prompted. You can run the logout command to log out and switch to another user.

  11. Log in to the operating system as the root user and run the yast2 command to log in to YaST Control Center.
  12. Use arrow keys to choose Network Devices > Network Settings and press Enter.

  13. Press Tab to select eth0 and press F4. The Network Card Setup screen is displayed.

  14. Press Tab to select Statically assigned IP Address and press Enter. Configure the IP address of the eth0 NIC, for example, 192.168.9.10/24.
  15. Press Esc to return to the Network Settings screen.
  16. Configure the IP addresses of other NICs in the same way.

  17. On the Network Settings screen, configure the host named AC-Node01.

  18. Configure the default gateway and static route, select OK, and select OK again.

  19. Select Quit to exit.
  20. Modify /etc/ssh/sshd_config to allow the root user to remotely log in. The root user's remote login permission is required during Agile Controller-DCN cluster deployment. If the swift user is used, skip this step.

  21. Run the service sshd restart command to restart the SSHD service. If the swift user is used, skip this step.

  22. Check the communication between the southbound address of the VM and the loopback address of each network device.

  23. Install the SUSE operating system on the other ESXi in the same way.
Download
Updated: 2019-03-25

Document ID: EDOC1100072313

Views: 2557

Downloads: 17

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next